The Machine Does Not Print - Ricoh LD225 Function Manual

The Machine Does Not Print

Possible Cause
Is the power on?
Is the machine online?
Does the printer function
status indicator stay red?
Is there a warning status or
error message on the dis-
play panel?
Does the "Updating the
destination list...Please
wait. Specified destina-
tion(s) or sender's name
has been cleared." message
appear?
Can you print a configura-
tion page?
Is the interface cable con-
nected securely to the ma-
chine and computer?
Are you using the correct
interface cable?
Was the interface cable
connected after the ma-
chine was turned on?
Is the signal status satisfac-
tory when using wireless
LAN in the infrastructure
mode ?
When using wireless LAN,
is the SSID correctly set?
Check the cable is securely plugged into the power outlet and the
machine. Turn on the main power switch.
If not, press [fOnline] on the display panel.
If so, check the error message on the display panel and take re-
quired action.
If so, check the error message or warning status on the display
panel and take the required action.
The destination list is being updated from the network using
SmartDeviceMonitor for Admin.
Depending on the number of destinations to be updated, there
may be some delay before you can resume operation. Operations
are not possible while this message is displayed.
Wait until the message disappears. Do not switch off the power
while this message is displayed.
If you cannot print a configuration page, there maybe a machine
malfunction. Contact your sales or service representative.
See p.126 "Printing the configuration page" for printing a config-
uration page.
Connect the interface cable securely. If it has a fastener, fasten that
securely as well.
See p.10 "Connecting the Machine".
The type of interface cable you should use depends on the com-
puter. Be sure to use the correct one. If the cable is damaged or
worn, replace it.
See p.10 "Connecting the Machine".
Connect the interface cable before turning on the machine.
To check signal status, press {User Tools/Counter} key on the dis-
play panel, and then press [System Settings] on the display panel.
On the [Interface Settings] tab, select [IEEE 802.11b], and then press
[Wireless LAN Signal]. If signal quality is poor, move the machine to
a location where radio waves can pass or remove objects that
might cause interference.
Note
❒ You can check signal status only when using wireless LAN in
the infrastructure mode.
Check using the machine's display panel that the SSID is correctly
set.
See "Interface Settings/IEEE 802.11b (Option)", General Settings
Guide.
Solutions
Troubleshooting
8
151