SOLE E20 Owner's Manual page 16

ASSEMBLY INSTRUCTIONS
UPPER
See Page 15 for Illustration
1.
Connect the Upper Swing Arm (L) (18) to the left Lower Swing Arm and
connect the Upper Swing Arm (R) (19) to the right Lower Swing Arm, and
secure them with six Hex Head Bolts (106), four Curved Washers (143) and six
Nyloc Nuts (129) by using the Wrenches (151 & 152).
#106.5/16"x 1-3/4"
Hex Head Bolt (6 pcs)
#129.5/16"x 7T
Nyloc Nut (6 pcs)
#143.5/16"x 23mm
x 1.5T Curved Washer
(4 pcs)
PLASTIC
See Page 15 for Illustration
1. Connect Swing Arm Wire (Lower), Resistance/Incline (50), Swing Arm Wire
(Upper), Incline (49) and connect Swing Arm Wire (Lower), Resistance/Incline
(50), Swing Arm Wire (Upper), Resistance (48). Push the excessive wires into
the Console Mast and plug in the Switch Wire Cap (100) at each side on the
Mast.
2. Attach front (89) and rear (90) Handle Bar Covers together on left Swing Arm
shaft and secure using two Sheet Metal Screws (122) and the Phillips Head
Screw Driver (150). Repeat this process for the right side Handle Bar Covers
(91) and (92).
3. Install Console Mast Covers (L & R) (81 & 82) on each side of the Side Cases
and secure with two Sheet Metal Screws (122) and the Phillips Head Screw
Driver (150).
4. Secure left Slide Wheel Cover (87) on left Pedal Arm with two Phillips Head
Screws (120) by using Phillips Head Screw Driver (150). Repeat this process
for the right Slide Wheel Cover (88).
5. Secure Console Chin Cover (Front) (93) on the Mast and then match with
Console Chin Cover (Rear) (94). Secure the covers with three Phillips Head
Screws (120), two Sheet Metal Screws (122) and the Phillips Head Screw
Driver (150).
6. Snap Rear Bar Cover (97) into the hole on the Incline Rail Assembly.
" ' F
#120. M5 x 15mm
Phillips Head Screw
(7 pcs)
#122. D3.5x 12mm
Sheet Metal Screw
(8 pcs)
#100. Switch Wire Cap
(2 pcs)
E20 / E25 ELLIPTICAL 14