SOLE E20 Owner's Manual page 14

ASSEMBLY INSTRUCTIONS
&CONSOLE
See Page 13 for Illustration
;T
1. Connect the Front Stabilizer Bar (2) with the Main Frame at the front joining
plate by using the Wrench (151) to tighten two Hex Head Bolts (112), two
Split Washers (14:2) and two Curved Washers (144).
2. Connect the Incline Rail Assembly (3) with the Main Frame at the rear joining
plate by using the Wrench (151) to tighten two Hex Head Bolts (112), two
Split Washers (14:2) and two Curved Washers (144).
3. Pull the wife, which is attached to the Computer Cable (38), out of
Console Mast (15) and secure the mast on the Main Frame by using M8 L
Allen Wrench (153) to tighten four Socket Head Cap Bolts (113) together
with four Split Washers (14:2) and four Flat Washers (139).
4. Plug in the connectors of the Computer Cable (38), two Handpulse W/Cable
Assemblies (White & Red) (44, 45), Swing Arm Wire (Upper), Resistance (48)
and Swing Arm Wire (Upper), Incline (49) on the back of Console Assembly
(35) and secure the Console Assembly (35) on the console holding plate with
four Phillips Head Screws (119) by tightening them with Phillips Head Screw
Driver (150).
• i
#112.3/8"x 3-3/4" Hex
Head Bolt (4 pcs)
# 11:3.3/8" x 3/4"
Socket Head Cap Bolt
(4 pcs)
#119, M5 x lOmm
Phillips Head Screw
(4 pcs)
#1:39. 3/8"x 19mm x
1.5T Flat Washer (4 pcs)
# 142.3/8" x 2T
Split Washer (8 pcs)
#144. 3/8"x 23 x 2T
Curved Washer (4 pcs)
LOWER
See Page 13 for Illustration
1. Attach the Lower Swing Arms (L) and (R), (12) and (13), on each side of
Console Mast shaft and secure with two Hex Head Bolts (104) and two Flat
Washers (138) by using the Wrench (152).
2. Insert the shaft of the left Connecting Arm (10) through the bushing on left
Pedal Arm (7) and secure with a Button Head Socket Bolt (115) together with
a Flat Washer (138) by using M5 L Allen Wrench (149). Do it the same way for
right Connecting Arm (11) and right Pedal Arm (8).
3. Remove the Rod End Shafts (20) which are pre-assembled on the left and
right Connecting Arms. Assemble the Connecting Arm with the Lower Swing
Arm and secure with Rod End Shafts (20) and the screw by using the M5 L
Allen Wrench (149).
|•
#104. 5/16"x 15mm
Hex Head Bolt (2 pcs)
#11S. 5/16"x 15mm
Button Head Socket Bolt
(2 pcs)
#138. _8.5 x 26ram x 2T
FlatWasher (4 pcs)
1:20 / 1:25 ELLIPTICAL 12