Poulan Pro 2750 Instruction Manual page 8

KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment Front Hand Guard
Tool \ i'13
(Bar Tool) "_ II_ /_
Muffler _
Chain "'_" JL_ L
Bar Sprocket Bar Oil _ _--_L,._._,
Hole
Flit Cap
Front Handle
r/ Starter Rope
_ ./_ ON/STOP
/ Switch
Fuel Mix Fill Cap
Starter Housing
Throttle
Lock-out
Rear
Handle
Cylinder Cover
Adjusting
Direction
of Chain
Travet
Throttle
Trigger
Choke/Fast
Idle Lever
Chain Brake
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LOCK-OUT
The THROTTLE LOCK-OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle speed are set by puff-
ing the CHOKE/FAST IDLE LEVER out fully
for cold starting or after refueling. The choke
provides additional fuel to the engine during
cold starting.
Guide Bar
Chain Brake Nuts
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs. The chain
brake activates automatically in the event of
kickback. The chain brake activates manu-
ally if the front hand guard is pushed forward.
The chain brake is disengaged by pulling the
front hand guard back toward the front han-
dle as far as possible.
CHAIN TENSION
It is normal for a new chain to stretch during
first 30 minutes of operation. You should
check your chain tension frequently. See
CHAIN TENSION in the ASSEMBLY sec-
tion.
,_ WARNING:
Muffler is very hot dur-
ing and after use. Do not touch the muffler or
allow combustible material such as dry
grass or fuel to do so.