Sears 139.53755 SRT Owner's Manual

S'o, _A/RS
OWNER'S MANUAL
Universal Remote Control
Converter Kit
Model 139.53755 SRT ('With I Remote Control)
Model 139.53756 SRT (With 2 Remote Controls)
NOTICE TO U. S. CONSUMERS:
Some states prohibit the selvice or repair of garage door
openers whch cannot be made to comptywith the safety
standards contained in UL 325 (1988 revision). In order
to comply with boththe letter and the spidt of these laws,
this universal remote control converter kit should not be
used with any Sears Craftsman® garage door opener
manufactured pdor to April 1, 1982.
UNIVERSAL REMOTE CONTROLS consist of a receiver
and remote control(s), The remote control sends a coded
signal from outside the garage. Inside the garage, the plug-
in receiver accepts the transmitted signal and starts the
door opener.
IMPORTANT: Disable your existing recaiv_ before
Installing this replacement unit. if thta Is not possible,
Io_lte re<_vm" mDfar fi"om origlrlml nvcelv_ as ix_ldble.
When Imltelllng two or more re_dvere In a gerege,
poeition them at least 10 feet apart to prevent etastronlc
WARNING
i i i i
CNldran opemlthg or pkqdng with a gar=gedcor opener
san thJure thenamlvne or olher&77_e Bsra_e Oborcou/d
dow xsd cacaesmfous/njury or desth.
Inetdl the r=_u (or any ediMIo.l pu¢ I:_lons) out
¢f the ma_ of _l_rco end awayfrom al movtBg parte
of the door and door hardware,bin"m _beBlrags
donr/sz,t_e. Donm snow cldldren te oplr_e _ pcah
bumca(s) or the remote onn_ol(s).
A moving_w'mgedcor om_d/njum Bomcone _er/t.
/_tfvete the opener only wizenthe door 18prol_rly
adjusted, you can see It clearly, and there are no
_ to doortbrav_.
Oiasoen_-'tpower to the garagedoor opener before
procsad_g.
To comply with FCC rules, adjtmtmentsor medifica_or_ of this
receiver and/or transmitter are prohibited, except for changing the
code setting or repladng the batte_. 3HERE ARE NO OTHER
USER SERVICEABLE PARTS,
OPENER RECENER: Insed a smallscrewdriverin sk:)t o n
receiverfrontpenal as shown.Twistup actuatorcover.
CONNECT RECEIVER AND OPENER: Remove about 1/4"of
insulation fromeash ond of the 2-strandbsilwire.Connest one
end to the racaiver screw _ (polarityis NOT required).
Routa wire ainngthe ohannels and outthe boftomes shown.
Cannect the othereed of the ballwire to the two ogener
terminalscrews labeled"whiteand red', "commonand
command"or the terminalsuesdfor the pesh buitoncontrd.
Use insulatedstaples (notsupplied)to secure bellwire
between recalver and oponer.Leng_ of bell wire depandaon
where the meek, o r willbe instaJled.Replecethe actualdrcove_.
Choosea 120Ves polarizedoust for the receivervAdchis
OUT OF THE REACH OF CHILDREN. Plug reselvm"Into
sek_'t_l oull_. Rotum power to the opener.
Actuator Cover
Power Indicator Light
J
Terminals
Indk:_dor
Light
BertW_ts
_Channe_s
Connect Bell Wire
To Garage Door
Opener Terminals
I
Bell Wire
The receiver and remote control(s) have been factory
preset with a matching code. THE REMOTE
CONTROL(S) OPERATES FROM THE LARGE PUSH
BUTTON. You can salivate your opener wllh =s many
ac four'SRT" remote controls and one Km/tau Entry.
If you purchase addilional remote controls to operate this
receiver:
1) Remove the receiver actuatorcover.
2) Press and HOLD the selected inmate control push button
(IllustrationA).
3) Than press the "SRT" actuator on the receiver
(illustration B). The adjacent indicator light will FLASH.
Release the remote controlpush button.
The opener will now operate when either the receiver
actuator or theremote control push button is pressed.
NOTE: If the remote control push button Is not he_d
down until the receiver Indicator Itght flashes, the
rtmelver will not tsem the code.
Toerase ALL r_note oontroi ood_ from memory:
Pnras an¢l HOLD receiv_r .'SRT"ao_uafu_.Indicator
I/ght aiongs/d_ wi/I glo_ When b_e ind/cator /lght tums
OFF (In aboutS secon_) AU. code_ wlll be enme_
A 3-Furm_o_ Remote Control
Select a remote co_tro_push
buttonto operate receiver
I REPLACEMENT PARTS: Remote Control Housing Only (no circuit board) 41A3888; Visor clip 29C128; Battery o 10A14;
I
Universal Receiver (cornp_ete)41A41S1; Receiver Actuator Cover- 41A3591 I
01994, Sears Roebuckand Company
114A1457B All RightsReserved Printedin Mexico