GE GFDN240 Owner's Manual page 12

Hide thumbs Also See for GFDN240:
Table of Contents

Advertisement

Available languages

Available languages

Reversing
the door swing.
STEP-BY-STEP INSTRUCTIONS(cont.)
Remove
Door Assembly
2. Open the door to approximately 130 degrees.
Remove
,\
\
\
3. Remove the 2 screws starting from the bottom to the top. Make sure the door is
supported while removing the screws.
Top
\\
\
\\
4. Loosen the top screw as shown. Unhook the door by lifting and pulling.
8-#8 Tap1 ng Screws
2 Beauty Buttons
6-# 8 Machine Tapping Screws
5. Place the door on a soft protected flat surface so the inner door faces upward
(door resting on handle side). Remove the 8 tapping screws located around the
perimeter of the door outlining the gasket. Remove the 6 machine screws. Using a
putty knife or any other flat tool, remove the 2 beauty buttons and install them on
the opposite side.
Outer Door Assembly
Remove
Hinge end Cover
IMPORTANT: Note the location of the hinge (left or right) before removing.
Hi!qe Assembly
Hinge Cover
6. With the screws removed, turn the door over and separate the outer door
assembly and hinge cover of the door from the door frame and set aside.
12

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Gfdn245Gfds350Gfds355

Table of Contents