Displays; Tv Screen And Video - Panasonic Diga DMR-XW390 Operating Instructions Manual

Hide thumbs Also See for Diga DMR-XW390:
Table of Contents

Advertisement

The unit is switched to standby mode
automatically.
• VIERA Link has worked. (
The remote control doesn't work.
• The remote control and main unit are using
different codes. Change the code on the remote
control.
Unit's display
• Software (firmware) is updating when "UPD
/ " is displaying on the unit's display. Wait until
the update is completed. (
• The HOLD function is activated. (
Startup is slow.
• Startup takes time in the following situations:
- A disc is inserted.
- The clock is not set.
- Immediately after a power failure or the AC
mains lead is connected.
- When the "Power Save in Standby" is
activated. (
77)
62, Power off link)
Press and hold [OK]
and the indicated
number button at the
same time for more
than 5 seconds.
(
77)
80)
81)

Displays

"0:00" is flashing on the unit's display.
• Set the clock. (
78)
The clock does not display on the unit when
switched to standby.
• The clock does not display when "Power Save
in Standby" is activated. (

TV screen and video

Screen size is wrong.
• Check the "TV Aspect" or "Aspect for 4:3 Video".
(
74)
• Adjust the aspect ratio setting on TV.
• If you connect to 4:3 TV, set "HDMI Video
Format" to "576p/480p". (
• Check "Aspect for Recording" before recording
or file conversion. (
The black screen appears on the TV.
• This phenomenon may occur, depending on the
TV setting, when "Power Save in Standby" is set
to "Off". Depending on the TV, this phenomenon
may be prevented by reconnecting to a different
HDMI input terminal.
Picture does not appear with the HD quality
although HD setting was made.
• The pictures are output with 576p/480p
depending on the title.
Troubleshooting
77)
66, 74)
66, 70)
VQT4C72
83

Advertisement

Table of Contents
loading

Table of Contents