Panasonic Diga DMR-XW390 Operating Instructions Manual page 12

Getting started
Control reference guide
Main unit
1 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
2 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
3 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
4 Open/close disc tray
5 Disc tray
6 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
7 USB port
8 Channel select
9 Start recording ( 23)
: Stop
; Start play
12
VQT4C72
Press [< OPEN/CLOSE] to open the tray and insert or remove a disc.
SD card
USB memory
Pull to flip down
the front panel.
< Display
HDDSDVD
4 5
1 SD card slot indicator
2 Copying indicator
3 Disc indicator
4 Drive (HDD, DVD or SD) indicator
5 Remote control signal indicator
6 Main display section indicator
- Current time
- Playback counter
- Various messages (
7 Playback indicator
8 USB port indicator
9 Timer recording indicator
• This indicator lights up when the timer
recording standby is activated.
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
1 2 3
COPY
SD USB
PLAY
6 7 8 9
88)