Start-Up Sequence Honeywell Gas Valve; Honeywell Electronic Ignition - Montigo H38DF ST Installation & Maintenance Manual

For Your Safety - READ BEFORE LIGHTING:
You must read and understand this manual prior to installation, operation or
troubleshooting this appliance. Please retain this owner's manual for furure reference
and maintenance.
A. This appliance is equipped with an ignition system that
lights the pilot burner automatically. Do not attempt to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
„
Do not touch any electrical switch; do not use any phone in
„
your building.
1. STOP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3. Turn switch on the gas control to OFF".
4. Wait 5 minutes to clear out any gas. If you smell gas,
STOP! Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5. Turn switch on the gas control to "ON". NOTE: This unit is
equipped with an ignition system that lights the pilot burner
automatically. Do not attempt to light the pilot by hand.
6. Turn on wall switch.
7. Replace the lower Horizontal access panel.
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
XG0207 - 011012.1
Operation

Honeywell Electronic Ignition

NOTICE
Lighting Instructions:
To Turn Off Gas To Appliance:
Models Included
H38FSDNE
HL38FSDNE
Immediately call your gas supplier from a neighbour's phone.
„
Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire Department.
„
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service technician.
Force or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system,
and any gas control which has been under water.
8. If the fireplace does not operate, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician
or gas supplier.
Gas
Inlet
Gas Control Switch
Shown in "On" Position
3. Turn the switch on the gas control to "Off".
4. Replace the lower Horizontal access panel.
H*38DF ST Indoor Gas Fireplace
H38FSDLE
HL38FSDLE
Page 25