Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
Congratulations on your purchase of a new Ride-Rite
Air Compressor Accessory Kit. This kit will be an asset to
your vehicle, meeting nearly any of your air supply needs.
Please take a few minutes to read through the
instructions, identify the components, and learn how to
properly install your Air Compressor Accessory Kit.
PARTS LIST
COMPRESSOR
AIR TANK
25 FT. EXTENSION HOSE
3/8" -16 x 1" HEX BOLT
3/8" -16 FLANGED HEX NUT
3/8" FLAT WASHER
10 -32 x 1" MACHINE SCREW
10 -32 NYLON-INSERT HEX NUT
3/16" FLAT WASHER
PUSH-TO-CONNECT
1/4 NPT MALE FITTING
24-8128
A
C
IR
OMPRESSOR
9210
1
9127
1
9006
1
4
4
4
3
3
6
1
AIR COMMAND
A
CCESSORY
NOTE:
If you are planning to install the Ride-Rite Fully
Automatic control or Cab Control Height Adjustment
systems, the Air Compressor Accessory Kit and the Ride-
Rite air helper springs kit designed to fit your vehicle must
first be installed. Contact Firestone for more information.
TOOLS REQUIRED:
• U
TILITY KNIFE
• F
LAT SCREW DRIVER
• W
IRE CRIMPER
• (2) 9/16"
PRESSURE SWITCH
COMPRESSOR T-FITTING
TANK VALVE
18 FT. AIR LINE TUBING
NYLON TIE
15 FT. 16 GAGE WIRE WITH 1/4"
SPADE CONNECTOR
QUICK-SPLICE CONNECTOR
FEMALE SPADE TERMINAL
20 AMP BLADE FUSE
FUSE HOLDER
03-01
2047 / 2232
K
IT
• 3/8"
• E
LECTRIC DRILL
/
• 1/2"
STRIPPER
-
• 3/8"
OPEN
END WRENCH
9038
NCD-5819-3
DRILL BIT
WRENCH
WRENCH
1
1
1
1
6
1
1
1
1
1
Advertisement
Summary of Contents for Firestone Sport Rite 9127
-
Page 1: Parts List
Automatic control or Cab Control Height Adjustment systems, the Air Compressor Accessory Kit and the Ride- Rite air helper springs kit designed to fit your vehicle must first be installed. Contact Firestone for more information. TOOLS REQUIRED: • U • F •... - Page 2 Air Tank Attachment Air Compressor Accessory Kit 1 - 1 ” - 1 3 / 8 WR1-760-2047 A I R ” F 3 / 8 ” L 3 / 8 25' Extension Hose Figure “A”...
- Page 3 Figure "B" location should provide ample air flow and be protected from most airborne debris. The surface should be rigid to support the unit. Some examples might include under the hood on a fender well, or in a vented storage compartment. AIR LINE FLAT WASHER PUSH-TO-CONNECT...
- Page 4 YOU ARE NOW READY TO TEST THE SYSTEM Turn on the ignition. The air compressor will run for a short time to build up pressure in the tank. Once this air pressure reaches approximately 120 psi in the air tank, the pressure switch will turn the compressor off. It will not restart until the pressure in the tank drops below 90 psi.