Scag Power Equipment STT Operator's Manual page 29

Section 6
To adjust the Custom-Cut Baffle height:
1. Place the cutter deck in the transport position.
2. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck. (See Figure 6.8).
-NOTE-
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on cutter deck size.
MOUNTING
HARDWARE
Figure 6-8. Custom Cut Baffle
3. Move the Custom-Cut Baffle to desired position.
(See Figures 6.9 through 6.11 for position).
4. Reinstall the mounting hardware as shown. (See
Figures 6.10 though 6.11). Torque hardware to
39ft.lbs.
Figure 6-9. 3" Custom Cut Baffle Position
BOTTOM SET OF HOLES
FOR 3-1/2" SETTING
Figure 6-10. 3-1/2" Custom Cut Baffle Position
MOUNTING
HARDWARE
2002 CCB
TOP SET OF HOLES
FOR 4" SETTING
2002 CCB - 3" Setting
25
FLATWASHER
FLATWASHER
Figure 6-11. 4" Custom Cut Baffle Position
CARRIAGE BOLT
2002 CCB - 3-1/2" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2002 CCB - 4" Setting
ELASTIC STOP
NUT