Table of Contents
Advertisement
Instructions for use
GB
English,1
IWME 147
WASHING MACHINE
Contents
Installation, 2-3-4-5-6-7
Technical details
Washing machine description, 10-11
Briefly: how to start a programme
Personalisations, 13
Detergent dispenser
Troubleshooting, 15-16
Assistance, 17-18
GB
1
Advertisement
Table of Contents
Related Manuals for Indesit IWME 147
Summary of Contents for Indesit IWME 147
-
Page 1: Table Of Contents
Cleaning the detergent dispenser Caring for your appliance door and drum Cleaning the pump Checking the water inlet hose Precautions and advice, 9 General safety IWME 147 Disposal Saving energy and respecting the environment Washing machine description, 10-11 Control panel Leds... -
Page 2: Unpacking And Levelling
Installation ! Keep this instruction manual in a safe place for Levelling your appliance correctly will provide it with future reference. Should the appliance be sold, tran- stability and avoid any vibrations, noise and shifting sferred or moved, make sure the instruction manual during operation. -
Page 3: Connecting The Drain Hose
Connecting the drain hose • the supply voltage is included within the va- lues indicated on the Technical details table Connect the drain (see page 5); hose, without ben- ding it, to a draining • the socket is compatible with the washing duct or a wall drain machine’s plug. -
Page 4: The First Wash Cycle
As the colours of the wires in the lead may ! The power supply cable must only be repla- not correspond with the coloured markings ced by an authorised serviceman. identifying the terminals in your plug, proceed as follows: Warning! The company denies all liability if Connect Green &... - Page 5 Technical data Model IWME 147 width 59.5 cm Dimensions height 81.5 cm depth 54.5 cm Capacity from 1 to 7 kg please refer to the technical Electrical data plate fixed to the ma- connections chine maximum pressure 1 MPa (10 bar) Water con- minimum pressure 0.05...
-
Page 6: Instructions For The Fitter
Instructions for the fitter Door Mounting Accessories (Fig. 1-2-3-4-5). Mounting the wooden panel onto the door and inserting the machine into cabinets: In the case where the machine must be shipped for final installation after the wooden panel has been mounted, we suggest leaving it in its ori- ginal packaging. - Page 7 Using the Drilling Template. - To trace the positions of the holes on the left- hand side of the panel, align the drilling template to the top left side of the panel using the lines traced on the extremities as a reference. - To trace the positions of the holes on the right- hand side of the panel, align the drilling template to the top right side of the panel.
-
Page 8: Care And Maintenance
Care and maintenance Cutting off the water or electricity 2. clean the interior thoroughly; supply 3. screw the lid back on. Checking the water inlet hose • Turn off the water tap after every wash. This will limit the wear of your appliance’s water Check the water inlet hose at least once a year. -
Page 9: Precautions And Advice
If you only see a little water through your appliance door, responsible for their safety. Children should be supervi- this is because thanks to the latest Indesit technology, your sed to ensure that they do not play with the appliance. -
Page 10: Washing Machine Description
Washing machine description Control panel FUNCTION ON-OFF/DOOR Buttons LOCK Leds ON-OFF Button PROGRAMME Detergent dispenser Knob SPIN SPEED START/RESET Knob Button TEMPERATURE Knob Detergent dispenser: to add detergent and fabric PROGRAMME knob: to select the wash programmes. softener. The knob stays still during the cycle. LEDS: to find out which wash cycle phase is under way. -
Page 11: Leds
Leds Cycle phase under way: During the wash cycle, the LEDs gradually illuminate on to indicate the cycle phase under way: The LEDS provide important information. This is what they can tell you: Prewash Delay set: Wash If the Delay Timer function has been enabled, once you have started the programme, the LED corresponding to Rinse the delay set will begin to flash:... -
Page 12: Starting And Programmes
Starting and Programmes Briefly: starting a programme 6. Add the detergent and any fabric softener. 7. Start he programme by pressing the START/RESET button. 1. Switch the washing machine on by pressing button . All the To cancel it, keep the START/RESET button pressed for LEDS will light up for a few seconds and the ON-OFF/ at least 2 seconds. -
Page 13: Personalisations
Personalisations Setting the temperature Turn the TEMPERATURE knob to set the wash temperature (see Programme table). The temperature can be lowered, or even set to a cold wash ( ). Setting the spin speed Turn the SPIN SPEED knob to set the spin speed for the programme selected. The maximum spin speeds for each programme are as follows: Programmes Maximum spin speed... -
Page 14: Detergents And Laundry
Detergents and laundry Detergent dispenser To run the bleach cycle alone, pour the bleach into extra compartment 4, set the Rinse programme and enable Good washing results also depend on the correct dose of the Stain removal option. To bleach during a wash cycle, detergent: adding too much detergent won’t necessarily pour in the detergent and fabric softener, set the desired pro- make for a more efficient wash, and may in fact cause... -
Page 15: Troubleshooting
Troubleshooting Your washing machine could fail to work. Before calling for Assistance (see page 16), make sure the problem can’t easily be solved by consulting the following list. Possible causes/Solution: Problem The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. - Page 16 The machine is noisy. • There will always be some motor, pump and drum noise during spin. The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly.
-
Page 17: Assistance
5 Year Parts Guarantee Indesit also offers you a free 5 year parts guarantee. This additional guarantee is conditional on you registering your appliance with us and the parts being fitted by one of our authorised engineers. There will be a charge for our engineer’s time. To activate the extra parts warranty on your appliance, simply call our registration line on 08448 24 24 24 (Republic of Ireland 01 230 0800). -
Page 18: After Sales Service
After Sales Service No one is better placed to care for your Indesit appliance during the course of its working life than us - the manufacturer. Essential Contact Information Indesit Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1100 fully qualified engineers on call to ensure you receive fast, reliable, local service. - Page 20 195105285.00 06/2012 - Xerox Fabriano...