Camera Assembly - GoPro Hero 3 White edition User Manual

camera assemblY

AssemBLinG the CAmerA
The HERO3 camera housing is waterproof to 197'/60m and is constructed of
polycarbonate and stainless steel for ultimate durability. The HERO3 has a new improved
latch closure that offers one hand open-and-close functionality and locking.
to place the hero3 camera into the housing:
1. Place camera in housing.
2. Position the backdoor into place.
3. Lift the latch arm into upright position allowing the hinged arm to
hang downward.
4. Hook grooved portion of hinged arm to grooved top of the backdoor.
5. Use one finger to push down the latch arm to snap into place.
to remove the hero3 camera from the housing:
1. Grip the housing with left hand.
2. Using right hand, place thumb to left side of arrow and index finger just
below latch arm.
3. Pinch fingers together, sliding arrow to the right.
4. Use fingertips to pull upward, allowing latch arm to swing to fully
upright position.
5. Lift hinged arm over the housing and remove the HERO3.
To close properly, be sure grooved sections of the latch arm and the backdoor
are hooked.
46