Advertisement
Youwill need:
• Wrench
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
• Replacement
spray gun filter (if
necessary)
IMPORTANT:
Never clean the filter by
poking it with a sharp object.
1. Peform the Pressure Relief
Procedure, page 7.
2.
Pull trigger guard from filter
housing.
3. Unscrew the filter housing using a
wrench.
4.
Remove the filter from the housing.
Clean with appropriate cleaning
solution (warm, soapy water for
latex materials; mineral spirits for
oil-based materials).
5. Inspect the filter for
damage.
Replace if any
holes or tears are found.
6.
Replace cleaned filter, tapered end
first, into the gun housing.
Note:
It is important to place
tapered end first to ensure proper
sprayer operation.
13
7. Reassemble the spray gun.
Advertisement
