Table of Contents Sat Up Installing Your TV Set ........Adjusting the Picture ........Antenna/Cable "IV Connection ......4 Adjusting the Sound ........Preparation Advanced Operation Location of Controls (TV Set) ......5 Selecting Stereo/SAP Broadcasts ...... 20 Location of Controls (Remote Control) ... 6 Locking Channels ..........
Antenna/Cable TV Connection You can use either an indoor or outdoor antenna to receive VHF and/or UHF channels. Channels 2 - 13 are VHF channels, and channels 14 - 69 are UHF channels. We recommend using an outdoor antenna for better picture quality. You can receive Cable TV by connecting a cable supplied by your local cable company.
Location of Controls (TV Set) For specific use of each control, consult the corresponding page numbers in brackets. Rear view Front view VIDEO/AUDIO terminals [27] • TV NIDEO button [27] • <,d O _" o <.J VOLUME _ buttons* [15] CHANNEL V/•...
However, this Remote Control must first be programmed to control other brands of VCR's and/or Converters. If ment that uses different codes, it will have to be you will be using your TV set with a TOSHIBA VCR, your reprogrammed for those codes.
Using the Remote with VCR or Cable TV Converter • To control a TOSHIBA VCR, first set the TV/CABLENCR switch to "VCR" position. The buttons shown below will then control the VCR. The rest of the buttons operate the TV as usual.
• This Remote Control is preprogrammed to operate TOSHIBA VCR's. • To use VCR's other than Toshiba models (or cable converter), perform the following procedures before operating. Refer to the "VCR code table = (or "Cable TV converter code table') on pages 10 and 11 to find the code number that corresponds to the brand name of your VCR (or converter).
Page 10
Remote Control (Continued) • In some rare cases, you may not be able to operate your non-Toshiba equipment with the supplied Remote Control. This is because your equipment may use a code that is not provided with this Remote Control. In this case, please use the equipment's own remote control.
Menu Function (General Instructions) We suggest you familiarize yourself with the procedure before using the Menu function. To adjust any "iV feature, the use of the Menu function is required. The adjustments that can be made to the TV appear on the screen.
SLOW PAUSE € _ .,÷ When channel programming is complete, you will see the message at the right. TOSHIBA PROGRAMM I NG COVIPLETED Press CHANNEL • or • to make sure the channel programming been done properly.
Page 14
Programming Channel Memory (Continued) CHANNEL •/• After performing the CH PROGRAM function, you can add or erase specific channels. POWER MENU TV/VIDEO VOLUME G OGQ®G Select the channel you want to erase using the CHANNEL • or • =----------4 --,--T button, or select the channel you want to add using the Channel Number buttons.
If a vacant channel is tuned or TV broadcast for a day is finished, the TV will automatically turn off after about 15 minutes. This feature does not operate in the VIDEO mode. TOSHIBA Last Mode Memory If the power is cut off while you are viewing the TV and the power is...
MUTE button again. (This feature only functions when the Closed Caption mode is set to "OFF".) TOSHIBA Press CH RTN to return to the last channel viewed. This is useful should you want to view two channels. This allows you to view two programs without entering an actual channel number each time.
Each time you press the button, the time display will increase Ol_)ordecrease (<) by 10 minutes. 0--'10 • 170--'180 To cancel the setting Press POWER twice, once to turn the TV off and once to turn it on again. FAV CH W/VIDEO TOSHIBA >...
Press MENU repeatedly until the Picture menu is displayed on the screen. FAV CH WMDEC TVNCR STOP PLAY Press • or • repeatedly until "RESET" T z_'_'_ ..I ..÷ is displayed in purple. SLOW P_ RESET TOSHIBA Press • or •. RESET 1...
WNIDEO TVNCR STOP PLAY sLOW pAUSE Select the STEREO mode as described above. Press SURROUND repeatedly until TOSHIBA "SURROUND ON" is displayed in purple. SURROUND " _L_RF'_OUND OFF TO SELECT PUSH SUR The surround function has now been activated. Note: "MTS"...
Page 21
When the TV receives a SAP broadcast, the word "SAP" is displayed on the screen. Press MENU repeatedly until the Audio menu is displayed on the screen. [STR]SAPMONO Press • or • until "MTS" is displayed in purple. If a SAP broadcast is received, "SAP" will be displayed in yellow.
STOP PLAY Pick a number that is easy to remember. SLOW PAUSE Example: To enter "1234" Press 1, 2, 3 and 4 in order. TOSHIBA 1--- -1'12"" "11"123 - 7H_4OCK--'----_. T V 1234 TO SELECT • • TO ENTER 4-DIGIT...
Page 23
Press • or • to lock out the channel. The display at the fight will appear on the screen for about 4 seconds. LOCKED 1234 Repeat steps 1 to 6 for other channels. This TV has 8 memory spaces total, 4 for the TV mode and 4 for the CABLE mode.
'Vii "O" replaces the channel number to be erased, "2" for example. Repeat steps 1 to 5 for other channels. TOSHIBA To select your favorite channels you have programmed, use the FAV • /• buttons on the Remote Control instead of using the CHANNEL buttons.
- When the signal reception is weak. - When the signal reception is non-standard. • If you select a closed-captioned channel and the Text mode, the text screen always appears. However, text characters are not displayed when no signal is aired. TOSHIBA...
PUSH W/VIDEO Operate the video equipment normally. Note: If you connect a monaural video equipment, connect the audio _utput of the video equipment to the L/MONO jack on the TV. FAV CH WNIDE( r-ri C_ ira- - _TVNIDEO FlEW TOSHIBA...
Cleaning and Care WARNING: TV sets use High Voltage. Do not try to remove the cabinet back. Refer servicing to qualified service personnel. • To clean the TV screen: • To maintain the finish and appearance of the cabinet, 1. First remove the plug from the power outlet to polish it from time to time with a quality furniture avoid possible shock hazard.
Before Calling Service Personnel Before calling service personnel, please check the following chart for a possible cause of the problem you are experi- encing. A minor adjustment on your part may eliminate the problem and restore your TV reception. Problem Checks and Adjustments Page "IV will not turn on...
Canadian consumers are requested to complete the special Canadian "Warranty Registration Form" enclosed, and forward \ this completed form with a copy of bill of sale to TOSHIBA OF CANADA to "Register and Validate" their warranty. purchased in the U.S.A. and used in canada are not covered by these warranties.
Page 32
INC. TOSHIBA AMERICA CONSUMER PROOUCTS, HEAD OFFICE/82 TOTOWA ROAD, WAYNE, NEW JERSEY 07470 FACTORY SERVICE CENTERS/NORTHEAST: 82 TOTOWA ROAD, WAYNE, NEW JERSEY 07470 MIDWEST: 1010 JOHNSON DRIVE, BUFFALO GROVE, ILLINOIS 60089-6900 WEST: 5490 E. FRANCIS ST., ONTARIO, CA 91761 SOUTHWEST:...