Advertisement
III. The indicator signal chart & Default：
Green LED
Red LED
Yellow LED
LED signal
1 Flashing Yellow LED
Blue LED
Flashing Blue LED
Bi
Bi－ x 2
Bi－ x 3
Audio
Bi－ x 5
Master code
Time delay of relays
Default value
Time delay of Keypad
Time delay of programming mode
Time delay of Invalid PIN Lock-out
IV. Wiring Diagram:
Attention:
The varistor or diode must be connected across the lock terminal (electric strike...) operated by the
device. The varistor controls the overload produced by the strike coil (EMP)
Cutting spare delay time after door closes for anti-passback: Time delay settled in 10 seconds. If the
door is closed in 3 seconds, the remaining 7 seconds will be ignored and door locks automatically once
the door closes.
V. Operation Instruction:
Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-DK100 Ver.B Published on 2007.09.12
Relay activated
Power on, stand-by
Programming mode
Key-in Code Confirmed
Controller Stand-by
Controller Locked
Key-in, Effective PIN codes
Entering or Exiting from the Program mode
Data computing error, other operation
mistakes
Master Code reset to default（12345）or
remove all stored user codes
12345 (changeable)
5 seconds
5 seconds
60 seconds
12345 (changeable)
Page: 2/ 3
Advertisement
