As you exercise, the
display will prompt you
to keep your pedaling
pace near the pace
setting for the current
segment. When the
MPH
word "faster" appears in the display, increase your
pace. When the word "slower" appears, decrease
your pace. When the center of the target flashes,
maintain your current pace.
IMPORTANT: The pace settings are intended
only to provide motivation. Your actual pace
may be slower than the pace settings. Make
sure to pedal at a pace that is comfortable for
you.
If the resistance level for the current segment is
too high or too low, you can manually override the
level by turning the Resistance dial. IMPORTANT:
When the current segment of the workout
ends, the pedals will automatically
adjust to
the resistance setting for the next segment.
If you stop pedaling for several seconds, the con-
sole will pause and the time will begin to flash in
the display. To restart the workout, press the Start
button or simply resume pedaling.
The workout will continue until the display shows a
time of 0:00. Note: If you continue to pedal after
the workout is completed, the display will continue
to show exercise feedback; however, the display
will not show the elapsed time until you select the
manual mode or a new workout.
Follow your progress with the display.
See step 4 on page 15.
Measure your heart rate if desired.
See step 5 on page 15.
When you are finished
exercising, the console
will turn off automatically.
See step 6 on page 15.
Page 16