Panasonic Palmcorder PalmSight PV-L779 Operating Instructions Manual page 45

Security Mode
Choose HIGH or LOW Audio sensitivity for
Audio or Motion.Audio Security.
I]g[€-]",_
Audio Security may start when:
• mic picks up any wind noise.
lUl[o_
Audio Security recording may not start
when:
• sound is too brief.
Note:
• Audio Security may mistakenly start when
normal noises are picked up. To avoid
this, place in quiet area.
• Camcorder location should be considered
when adjusting Audio sensitivity.
• Performance may vary due to
spaciousness of area, noise reflection,
and resonance.
• Do a test to confirm performance.
• While in Audio Security stand-by, the
following functions are not available:
Record/Pause, Stand-by mode, Digital
E.I.S., Time Lapse, Message, Auto Fade,
Digital Fade, Digital Filter.
Before you begin...
• Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
• Insert cassette with record tab (page 14).
• Set POWER to CAMERA.
• Securely position and aim Camcorder.
1
2
in page 44 steps
1-3.
Make sure, that SECURITY, in the
Menu mode, is set I""
se_n_e "'-
to AUDIO o.r
MOTION'AUDIO I_._AU= °
SI_.EC:T: _ VI& I<EY
L_ : PUSH DISPLAY K]E
Press DISPLAY for AUDIO
SENSITIVITY menu. Press _ or
to select(-.., sEcu,n_uooE -.- "_
HIGHorLOW. t _o,_ /
SELECT: PUSH VI& KEY
: PUSH DISPLAY
Picks up normal voices up to about
32.8 feet (10m) away.
Picks up normal voices up to about
3.2 feet (lm) away.
3
Press DISPLAY to confirm entry.
Press _ for Audio Security
stand-by mode or Motion-Audio
Security stand-by mode. (If cassette
is not inserted, "_" will flash.)
"I I,oolo ,o:o
SECURITY I MOTION.AUDIO
STAND-BY J
• Recording will start about 3 seconds
after motion and/or audio is detected.
• Date and time are recorded if
displayed in EVF (page 20).
• Recording stops 30 seconds after
motion and/or audio ceases.
To cancel Security Mode, set POWER to
OFF.
45