Panasonic Palmcorder PalmSight PV-L779 Operating Instructions Manual page 30

Playing Back Recordings
I i!!I/_i,_[,4:g,]
ivI [_,,,lni[01
Connect Camcorder to a "IV to view
playback or recordings in progress.
TV with AUDIO/VIDEO IN Jacks.
TV
To Audio In
Audio/Video
Cable
(Supplied)
Before you begin...
• Connect Camcorder to power source.
• Make all TV-Camcorder connections.
1
2
3
Set POWER to:
VCR _ view playback.
CAMERAr-_ view picture as it is
recorded.
Turn TV ON and set to I.INE
INPUT.
See TV owner's manual.
Begin playback or recording.
To Audio/Video Out
_.TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
If TV has no VIDEO/AUDIO IN jacks,
connect PV-RF16 RF Adaptor
(optional, page 76). Tune TV to CH 3
or 4 to match RF Adaptor 3/4
switch. Set Adaptor's TV/VCR
switch to VCR for playback.
RF Adaptor
_ VHF Antenna
300 ohm-75 ohm
transformer
or F Connector
UHF Antenna"
VCR/TV _
Selector
-- Back of TV 7
VHF Connecting
_ I
Cable
To VHFAntenna _ I
Terminal
To watch TV only,
turn TV on without AUDIONIDEO IN Jacks
connected (left).
a Set Camcorder POWER to OFF.
b Set RF Adaptor VCRFr:v Selector to TV.
c Turn TV ON and select channel.
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
30
I i°] i'=i'!"li-'i _'lii*_ _ '_-ul I IiIolo_i I I "J'll r:TIPJ._J' I