NordicTrack C2100 User Manual page 8

5, Remove theknobfromthepin,Makesurethatthecollar
andthespring areonthepin,
Press theLatchinsert ( 77)intotherightsideandthebft
Upright ( 85),andpresstheKnobinsert(92)intothebft
sideofthebft Upright, U sea rubber m allet, i f necessary,
Next,insert t hepinintotheLatchinsert, a ndtighten the
knobbackontothepin,
KnobJ-_
77
ring
Collar
.@(_in
6, Makesurethatall partsarepropertytightenedbeforeyou usethe treadmill.Keep theincluded allen
wrench in a secure pUace, Theallenwrench is usedtoadjust t hewaUking beUt (seepage 26),Toprotectthe
floor or carpetfromdamage, p lacea matunderthe treadmill.
if you purchase the optional chest puJse sensor (see page 22), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1, Make sure that the power cord is unplugged. Remove
the indicated Screw (99) and the Access Door (95) from
the left side of the Console Back (98),
2, Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (98), Hotd the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws,
3, Make sure that no wires are pinched. Reattach the
Access Door (95) with the Screw (99), Discard the other
wires included with the receiver,
..... Wire
95_---@
// A/____ _ /
sma,, I1
o o