Bosch TAS6515UC - Tassimo Single-Serve Coffee Brewer User Manual page 21

18
Problem
Water dripping from
the brewing unit.
Water on the surface
under the cup stand.
Service T DISC is
damaged or lost.
Fill tank lights up
P
even though there is
sufficient water in the
tank.
7d and 7e
P Q
are flashing simulta-
neously and it is not
possible to prepare
drinks.
Descale flashes
Q
even though you
are using filtered or
softened water.
Memo display is not
working anymore.
Cup lighting and LC
display have turned off
Can I turn off the cup
lighting?
Bosch Home Appliances
Possible cause
The T DISC is damaged or
leaky.
The piercing unit is either
not inserted or not inserted
properly.
Water from condensation.
The Service T DISC must
always be used for cleaning
and descaling processes.
The float in the water tank is
stuck.
There is an error on the
machine.
Even filtered water contains
small amounts of dissolved
lime.
Reset or purchase new one.
After 5 min. of inactivity,
machine automatically
reverts to stand-by mode to
save energy
–
Solution
Stop the brewing process,
remove the T DISC and clean
the brewing unit.
Check to ensure that the
piercing unit is inserted
properly.
Condensation may occur and is
not a fault. Remove it by wiping
with a cloth.
A Service T DISC can be pur-
chased from www.tassimo.com
or from TASSIMO or Bosch Cus-
tomer Service Department at 1-
877-TDISCS1 (1-877-834-7271).
Clean the water tank and
ensure that the float can move.
Turn the machine off using
the on/off switch, wait
approximately 5 minutes and
turn the machine back on. If
7d and 7 e are still
P Q
flashing, please contact the
TASSIMO or BOSCH Customer
Services Department at 1-877-
TDISCS1 (1-877-834-7271).
Descale the appliance.
Contact the TASSIMO or Bosch
Customer Service Department
at 1-877-TDISCS1
(1-877-834-7271).
To re-activate, please open
and close brewing unit or touch
start/stop button
No, the cup lighting is automati-
cally switched on and off when
the machine is activated.
EN