TURN CLOCKWISE TO
RAISE CABINET CORNER
TURN COUNTER-CLOCKWISE TO
LOWER CABINET CORNER
Front Base Grille Ion
select models)
The front base grille (select models) which was
packaged inside the refrigerator
for shipment
and
should be installed after the refrigerator
has been
leveled.
"Snap
on" style:
• To install, align the spring clips with the round
openings
in the cabinet and push each end in until the
grille locks into place.
• To remove this style of base grille, grasp both ends
and pull straight out.
"Screw
on" style:
Use a Phillips screwdriver
to
remove the two Phillips head
screws at the base of the
refrigerator.
• Align the base grille to the screw holes. (The cut out
side on the base grille installs around the lower hinge
of the door.)
• Secure the base grille into place by reinstalling
the
Phillips screws back into their original screw holes.
• Reverse these steps to remove this style of base grille.
Energy Saving Tips
• Locate the refrigerator
away from heat producing
appliances
such as the range or dishwasher,
heat
vents and direct sunlight.
• Level the refrigerator
and do not block ventilation
around the front base grille.
• Let hot dishes cool slightly before putting into the
refrigerator
or freezer.
• Cover liquids.
Keep the freezer full to near capacity so less cold air
will escape during door openings. When the freezer is
less than 2/3 full, place milk cartons half full of water in
the freezer.
• Wipe moisture from the outside of containers
before
placing them into the refrigerator.
• Avoid opening the doors too often.