Make Gas Connection - Jenn-Air 720-0720 Use & Care Manual

Freestanding outdoor grills installation instructions
Table of Contents

Advertisement

Available languages

Available languages

NOTE: If grill is to be converted to Natural gas, follow instructions
To Connect
the 20 Ib LP Gas Fuel Tank:
in the "Gas Conversions"
section.
20 Ib LP Gas Fuel Tank
Explosion Hazard
Securely tighten
all gas connections.
if connected to LP, have a qualified
person make sure
gas pressure does not exceed 11" (28 crn) water
column.
Examples of a qualified
person include:
licensed heating personnel,
authorized
gas company
personnel, and
authorized
service
personnel.
Failure to do so can result in death, explosion,
or fire.
LP Gas:
IMPORTANT: A 20 Ib LP gas fuel tank must be purchased
separately.
IMPORTANT: The gas pressure regulator/hose
assembly
supplied with the grill must be used. Replacement gas pressure
regulator/hose
assembly specific to your model, is available from
your outdoor grill dealer.
Door Style Tank Tray
1. Open cabinet doors.
2. Slide the tank tray locking bracket clockwise 90 ° and pull out
the tray.
......................................................
A
A. Tank tray
locking
bracket
3. Place the 20 Ib LP gas fuel tank bottom collar into the
mounting hole in the tank tray.
4. Tighten the locking screw against the bottom collar of the
20 Ib LP gas fuel tank to secure.
S
...............................
_
...........................
A
C
A. Locking screw
B. Mounting hole
C. Bottom collar
1. Check that the 20 Ib LP gas fuel tank is in the "Off" position. If
not, turn the valve clockwise until it stops.
2. Check that the 20 Ib LP gas fuel tank valve has the proper
type-1 external male thread connections
per ANSI Z21.81.
3. Check that the burner control knobs are in the "Off" position.
4. Remove any debris and inspect the valve connections,
port,
and gas pressure regulator/hose
assembly for damage.
NOTE: Always keep the LP cylinder at 90 ° (upright)
orientation to provide vapor withdrawal.
5=
Using your hand, turn the gas pressure regulator/hose
assembly clockwise to connect to the 20 Ib LP gas fuel tank
as shown.
Hand tighten only. Use of a wrench could damage the quick
coupling nut.
A
A. Gas pressure regulator/hose
assembly
B. 20 Ib LP gas fuel tank
Make sure that the cylinder valve connection device properly
mates with the connection device attached to the inlet of the
pressure regulator.
6. Open the tank valve fully by turning the valve
counterclockwise.
Wait a few minutes for gas to move
through the gas line.
7. Before lighting the grill, test all connections by brushing on an
approved noncorrosive leak-detection
solution. Bubbles will
show a leak.
8. If a leak is found, turn the tank valve off and do not use the
grill. Contact a qualified gas technician to make repairs.
9. Go to "Check and Adjust the Burners" section.
5. Slide the tank tray with the 20 Ib LP gas fuel tank back into
the cabinet and lock the locking bracket.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

730-0720

Table of Contents