Frigidaire GLWS1439FS2 Operating Instructions

WASH/RINSE TEMPERATURE
WARM
COLD
HOT COLD
COLD COLD
OPERATING INSTRUCTIONS
EXTRA RINSE LOAD SIZE
SMALL
MEDIUM
I
SUPER
RESET
SOAK &
PREWASH
PREWASH
15 12 8 4
WHITES
RINSE
POWER SPIN
SOAK
0
0
EXTRA RINSE
SPIN
RINSE
O
HAND WASH b 12
6 8
KNITS & COLORS
DELICATES
PERM PRESS
PREWASH
Before Operating Your Washer
Cycle Selection
Read your Washer Owner's Guide. It has important
safety and warranty information. It also has many
suggestions for best washing results.
To reduce the risk of fire, electric shock,
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your Washer Owner's Guide before
operating this appliance.
Operating Steps
Read Washing Procedures in your Owner's Guide.
It explains these operating steps in detail.
1. Sort laundry into loads that can be washed
together.
2. Prepare items for washing.
3. Pretreat stains and heavy soil.
4. Add the measured amount of detergent to
wash tub before adding the laundry load.
Printed in U.S.A.
5. if desired, add liquid bleach to bleach dispenser.
DO NOT pour bleach directly onto the load.
6. if desired, add liquid fabric softener to fabric
softener dispenser. DO NO T pour fabric softener
directly onto wash load.
7. Add laundry load loosely to wash tub. Dry load
should not be higher than top of agitator vanes.
For best results, DO NOT overload.
8. Select the wash cycle and settings according to
type, size and soil level of each load.
9.
Close lid and pull out Cycle Selector knob to
start washer. The washer will not fill with water,
agitate or spin when the lid is open, and will only start
to do so if the lid is closed.
To stop the washer, push in the Cycle Selector knob.
To change a cycle, push in the Cycle Selector knob
and turn it clockwise to the desired setting. Pull out
the knob to restart the washer.
10. Remove items at end of cycle. Wait about 2-3
minutes for safety lid lock to release.
Push in and turn the Cycle Selector knob clockwise
to the desired cycle. For best results, follow the
washing instructions on the fabric care labels.
The Whites, Colors and Knits & Delicates cycles
progress through wash agitation, drain and spin
with a spray rinse, rinse agitation, and a final spin.
Whites Cyde
This cycle provides up to 15 minutes of normal agitation
and a fast spin for most fabrics.
Power Spin provides 12 minutes of spin for maximum
removal of water. This conserves energy by reducing
drying time.
Extra Rinse Cycle
Use the Extra Rinse cycle after any complete wash
cycle when an additional deep rinse may be needed
to remove excess detergent and soil. It provides 3
minutes of rinse agitation in cold water, followed by
a spray rinse at the selected rinse water temperature
during spin.
if desired, add liquid fabric softener to this rinse
(not the fabric softener dispenser) or use a softener
sheet in the dryer. DO NOT pour fabric softener
directly onto the load.
P/N 137123000 (0809)