Lock (Parental Control); Initial Settings; Initial Setting The Area Code; Rating - JVC RX-THG51 Instructions Manual

5.1 Speaker Setup
Test
Press • / • to test the signals of each speaker. Adjust
the volume to match the volume of test signals
memorized in the system.
Front Left (Front L) -> Center-> Front Right (Front R)
-> Rear Right (Rear R) -> Rear Left (Rear L) ->
SubWoofer
LOCK (Parental Control)
Initial Setting the Area Code:
See the Area Codes on page 23.
1. Select the LOCK menu and then press •.
2. To access the LOCK options, you must input the
password you have created. Input a password and
press ENTER. Enter it again and press ENTER to
verify. If you make a mistake before pressing
ENTER, press CLEAR.
3. Select the first character using • / • buttons.
4. Press • and select the second character using
• / • buttons.
5. Press ENTER to confirm your Area code selection.
Rating
Blocks playback of rated DVDs based on their
contents. Not all discs are rated.
1. Select "Rating" on the LOCK menu then press •.
2. Input a password and press ENTER.
3. Select a rating from 1 to 8 using the • / • buttons.
Rating 1-8: Rating one (1) has the most restrictions
and rating eight (8) is the least restrictive.
Unlock: If you select unlock, parental control is
not active and the disc plays in full.
4. Press ENTER to confirm your rating selection, then
press SETUP to exit the menu.
Password
You can enter or change password.
1. Select Password on the LOCK menu and then
press •.
2. Follow the step 2 as shown above (Rating).
To change the password, press ENTER when the
"Change" option is highlighted. Input a password
and press ENTER. Enter it again and press
ENTER to verify.
3. Press SETUP to exit the menu.
If you forget your password
If you forget your password, you can clear it using the
following steps:
1. Press SETUP to display the Setup menu.
2. Select the LOCK menu.
3. Input the 6-digit number "210499" and press
ENTER. The password is cleared.
Area Code
Enter the code of the area whose standards were
used to rate the DVD video disc, based on the list on
page 23.
1. Select "Area Code" on the LOCK menu then
press •.
2. Follow the step 2 as shown previous paragraph
(Rating).
3. Select the first character using • / • buttons.
4. Press ENTER and select the second character
using • / • buttons.
5. Press ENTER to confirm your Area code selection.
OTHERS
This option has no selection on this set.