Connecting Internal Headers; Front Panel Header - EVGA nForce 122-CK-NF68-XX User Manual

Connecting Internal Headers

Front Panel Header

The front panel header on this
motherboard is one connector used to
connect the following four cables:
PWRLED
Attach the front panel power LED
cable to these two pins of the connector.
The Power LED indicates the system's status.
When the system is in S0 status, the LED is
on. When the system is in S1, S3, S4, S5
status, the LED is off.
Note:
The power LED cable in some chassis is a three pin
connector with the pins installed in positions 1 and 3. If your
chassis has a three pin connector, you will need to remove
pin 3 and put it into position 2 or you can use a pair of
scissors to cut out position 2. Most chassis come with a two
pin connector.
PWRSW
Attach the power button cable from the case
to these two pins. Pressing the power button
on the front panel turns the system on off rather than using the power
supply button.
HD_LED
Attach the hard disk drive indicator LED cable to these two pins. The HDD
indicator LED indicates the activity status of the hard disks.
RESET
Attach the Reset switch cable from the front panel of the case to these two
pins. The system restarts when the
Hardware Installation
No
Connect
RESET
9
10
Blank
PWRSW +
switch is pressed.
RESET
HD_LED
+ -
1
2
1
-
PWRLED
21