Advertisement
How to set the
Door Alarm
You don't have to set the visual
alarm° As long as either door is
open, the red DOOR OPEN signal
light flashes
If the green signal light on the
DOOR ALARM pad is glowing, the
beeper alarm is set,, If it's not, touch
the pad to turn it on.
If either door is open for more
than 30 seconds, a recurring
beep
sounds.
The light goes out and the beeping
stops when you close the door.
There are times when you'll want
the Door Alarm beeper turned off.
When you're rearranging
a lot of
food, for example. Just touch the
pad. The green light will go out and
the beeping will stop.
Deactivating
the Door Alarm
beeper does not turn the red DOOR
OPEN light off--it
keeps flashing
until the door is closed.
Why the red Warm
Temperature
light glows.
At first, it's probably because your
newly-installed
refrigerator
hasn't
completely
cooled down yet. Wait a
few hours for it to coot, and then
the light will go out.
From then on, the red light will glow
whenever temperatures
inside get
too high for proper food storage
If
this happens, open the doors only
when absolutely
necessary, and
close them as quickly as possible
As soon as inside temperatures
return to normal, the light goes out
7
How the Electronic
Monitor
and Diagnostic
System
works.
The word NORMAL
is lighted in
green except when a failure has
been detected
The SYSTEM CHECK pad has two
functions:
1 You can touch the SYSTEM
CHECK pad and get a review of the
electronic
diagnostic codes in order
of their priority
2 If a fault code is flashing, you
can touch the SYSTEM CHECK pad
to erase that code and check for
other failures
(continued
next page)
Pad No 468326P01
Advertisement
