Advertisement
E ectroHic Monitor & Diagnostic System
Btkeeps an eye on
things for you.
@
Q
Red signal light flashes to tell
you when either door is open
Green signal light tel is you that
the Door Alarm beeper has been
set to sound after either door has
been open 30 seconds
Red signal light tells you when
freezer foodkeeping
temperature
is
above normal
(_Green
lighted word NORMAL
indicates that no failure has been
detected by the diagnostic
system
Flashing green diagnostic codes
in the display warn you when:
_
frozen foods should be
checked,
_
power has been interrupted,
icemaker may not be operating
properly
defrost system has failed
freezer control may need to be
set for a colder temperature
What these codes mean--and
what
to do when they appear--is
sum-
marized on the inside of the freezer
compartment
door and explained
more thoroughly on the following
pages
System Check pad puts a review
of the electronic
diagnosis of five
coded functions at your fingertip
and also allows you to erase codes
from display
(_
Electronic control allows you
to turn night light in water-andqce
dispenser on and off.
Electronic control allows you
to select ice cubes or crushed ice,
and green signal light confirms
your choice
When your refrigerator
is first plugged in...
All panel lights come on for five
seconds, a beep sounds, and lights
go off except as follows:
o PF flashes in the display Touch
SYSTEM CHECK-RESET
pad to
erase it
o Green word NORMAL
glows,
o Red WARM TEMPERATURE
light glows if freezer compartment
temperature
is higher than normal,,
It goes off when proper foodkeeping
temperature
is reached,,
• Door alarm beeper is activated
and green light on DOOR ALARM
pad glows,,
o CRUSHED ice selection
light
glows,
• Red DOOR OPEN light flashes if
either door is open, goes out when
doors are shut,
o Night light in water-and-ice
dispenser is off.,
(continued
next page)
Advertisement
