Advertisement
Step 5: Find the Installation Instructions for Your Model
Each tiller's distinctive tine pattern provides the optimum in tilling performance for that model. Be sure to
install tines in the pattern described for your tiller. Find your tiller in the following list and go to the indicated
page to continue with tine installation.
❑
HORSE (Welded Steel Tine
Holders), see the instructions
at the bottom of this page.
❑
HORSE (Cast Iron Tine
Holders), see Page 8.
❑
PONY, see Page 12.
❑
ECONO HORSE, see Page 14.
Order of Installation
On all models, tines will be
installed in the following order
(see Figure 6):
A Left Inner Holder
B. Right Inner Holder
C. Left Outer Holder
D. Right Outer Holder
NOTE: When installing the
tines you will be directed to
perform a two step procedure
and then check to ensure that the
installation is correct before
going on to the next step.
HORSE MODEL TINE INSTALLATION
(WELDED STEEL HOLDERS)
Use this procedure to install
tines only if your tine holders are
shaped as shown below in
Figure 7.
Figure 7: Welded steel tine holder.
4
C
A
Figure 6: Order of installation on holders (welded steel holders shown).
NOTE: Be sure to use the
specific tines (left or right
curved) called for in each
installation step.
Step 1: Position Holders
Before Starting Tine
Installation
On PTO Models, disengage the
PTO Lever. On non-PTO
Models, place the Forward/
Reverse Lever in Neutral.
Rotate the tine holders and
shaft (by hand) until any one of
the semi-circles on the outer
mounting plates of the holders is
at the 12 o'clock position in
relation to the ground. See
Figure 8 on Page 5.
B
D
Step 2: Install Tines on Left
Inner Holder
Tines used in this step:
two right-curved tines
followed by
two left-curved tines
A. Place two right-curved tines
(shown shaded in Figure 8)
opposite each other on the
previously installed bolts. Make
sure that the tines are positioned
as follows:
✔ Tines are across from each
other.
✔ Tines are against the outer
surface of the left inner holder
plate.
Advertisement
