Download Print this page

Troy-Bilt OEM-290-253 Installation Instructions Manual page 15

Bolo tine kit for horse, econo horse, pony tillers

Advertisement

Step 2: Install Tines on Right
Outer Holder
Tines used in this step:
two left-curved tines
followed by
two right-curved tines.
A. Place two left-curved tines
(shown shaded in Figure 24)
opposite each other on the bolts
which were previously installed.
Make sure that the tines are
positioned as follows:
✔ The tips of these two tines
should be directly opposite and
point toward the tips of the two
tines installed in Step 1-A. See
Figure 25.
✔ Tines are across from each
other.
Figure 25: ECONO HORSE tines installed.
✔ Tines are against the outer
surface of the right holder outer
plate.
✔ Tips point inward toward
the transmission housing.
✔ The cutting edges will enter
the soil first when the tiller
moves forward.
B. Place two right-curved tines
(shown unshaded in Figure 24)
opposite each other, overlapping
the tines positioned in Step 2-A.
Make sure that the tines are
positioned as follows:
✔ Tines are across from each
other.
✔ Tips point outward toward
the sides of the tiller.
✔ The cutting edges will enter
the soil first when the tiller
moves forward.
C. Add lock washers and nuts to
all four bolts and tighten
securely.
Innermost Tines
Innermost Tines
Check the Installation
This completes the tine instal-
lation of tines on the ECONO
HORSE Model. To ensure that
the installation is correct, check
for the following:
Make sure that the tips of the
four innermost tines on the
outer holders are pointing
toward each other and
inward (toward the trans-
mission housing). See
Figure 25.
Make sure that the cutting
edges of all tines will enter
the soil first when the
tiller is moving forward.
Also read and follow the
instructions provided in the Bolo
Tines Maintenance Section on
Page 16.
15

Advertisement

loading

This manual is also suitable for:

290-253-081