Download Print this page

Troy-Bilt OEM-290-253 Installation Instructions Manual page 12

Bolo tine kit for horse, econo horse, pony tillers

Advertisement

PONY MODEL BOLO TINE INSTALLATION
Follow these installation steps
if you own a PONY Tiller.
ECONO HORSE owners
follow only Steps 1 and 2
below.
Step 1: Install Tines on Left
Inner Holder
Tines used in this step:
four right-curved tines
A. Begin installing new tines on
the left inner holder. See
Figure 21.
B. Carefully place two right-
curved tines (shown shaded in
Figure 21) opposite each other
on the previously installed bolts.
Make sure that tines are posi-
tioned as follows:
✔ Tines are across from each
other.
✔ Tines are against the outer
surface of the left holder inner
plate.
✔ The tips point inward
toward the transmission housing.
✔ The cutting edges will enter
the soil first when the tiller
moves forward.
C. Place two more right-curved
tines (shown partially shaded in
Figure 21) opposite each other
on the bolts, overlapping the
tines installed above in Step 1-B.
Make sure that the tines are
positioned as follows:
✔ Tines are across from each
other.
✔ The tips point inward
toward the transmission housing.
✔ The cutting edges will enter
the soil first when the tiller
moves forward.
D. Add lock washers and nuts to
all four bolts and tighten
securely.
12
Right-curved
Tines
NOTE: To allow an
unobstructed view of the left
inner holder, the left outer
holder is not shown.
Figure 21: Installing tines on left inner tine holder.
Step 2: Install Tines on Right
Inner Holder
Tines used in this step:
four left-curved tines
Install the four left-curved
tines on the outer surface of the
right inner holder (see Figure
22) using the procedure given
Figure 22: Installing tines on right inner tine holder.
ECONO HORSE owners should now go to the instructions for
the Left Outer Holder on Page 14 to complete tine installation.
Right-curved
Tines
in Step 1 for the left inner holder.
(The tips of the first two tines
installed in this step should be
directly opposite and point
toward the tips of the first two
tines installed in Step 1-B.)
Make sure that the tips of all
tines point inward, and that all
cutting edges face forward.
Left-curved
Tine

Advertisement

loading

This manual is also suitable for:

290-253-081