Download Print this page

Ariens 915131-Zoom 34 Owner's Manual page 24

Zoom series

Advertisement

ADJUSTING
STEERING
LEVERS
Adjusting
Steering
Lever Height
(Figure 18)
1. Handlebar
2. Steering Lever
3. Mounting Hardware
4. Adjustment
Holes
5. Eccentric Spacer
6. Shipping Adjustment
Holes
Figure 18
NOTE: Perform steps 1 and 2 for both
steering levers.
1. Remove mounting hardware and move
handlebar up or down until the steering
levers are at the appropriate height.
2. Install mounting hardware.
NOTE: Align handlebars by adjusting
eccentric spacer until the handlebar height is
the same.
Forward
Speed
Adjustment
(Figure
19)
NOTE: Reverse speed cannot be adjusted. If
unit tracks excessively left or right in reverse,
see your Dealer for repair.
IMPORTANT:
The unit should track within
2 feet (0.61 m) of a straight line for 30 feet
(9.14 m).
The travel of the steering levers may need
adjustment
if the unit turns to the right or left
when both steering levers are pushed as far
forward as possible.
NOTE: The side the unit turns toward
indicates that the wheel on that side is turning
slower than the other wheel. Either the wheel
that is turning faster needs to slow down or
the wheel that is turning slower needs to
speed up to allow the unit to travel in a
straight line.
1. Determine which way the unit turns.
2. Loosen jam nut on the adjustment bolt.
3. Adjust speed by:
Turning adjustment bolt clockwise to
decrease steering lever travel.
Turning adjustment bolt
counterclockwise
to increase steering
lever travel.
4. Tighten the jam nut.
1. Forward Travel Adjustment Bolt
2. Steering Lever
Figure 19
GB - 24

Advertisement

loading