Zoom G2.1Nu Operation Manual page 14

Using the Looper
4. Record a phrase and play it back
Press the [▲] foot switch, and play the phrase that you want to record.
"REC" appears on the display and recording starts.
Depending on the recording method chosen in step 2, recording occurs as follows.
■ If a note mark was chosen
Recording continues for the set time and then loop
playback starts (and "PLAY" appears on the display).
Playback
Recording
Set time
[▲] foot switch
When using the looper, the unit can also play a rhythm (→P16). However, the
HINT
parameter knobs only control the looper.
5. Overdub a phrase
During loop playback, press the [▲] foot switch.
"REC" appears on the display and overdubbing starts.
When the end of the recorded phrase is reached, playback returns to the loop beginning and overdubbing continues.
14
■ If "Manual" was chosen
When the [▲] foot switch is pressed again, or the
maximum time (about 5 seconds) is reached, loop
playback starts (and "PLAY" appears on the display).
Loop playback
Playback
Recording
switch
[▲] foot switch
[▲]
foot
ZOOM G2Nu/G2.1Nu
Loop playback