Reducing Wind Noise During Recording; Restoring All The Recording Settings To Default (Full Auto) - Hitachi DZ-BD70E Instruction Manual

HDD BD-R RAM -RW (VR)
BD-RE
Reducing Wind Noise
During Recording
When recording sound from the built-
in microphone, you can reduce wind
noise in the recording when the MIC.
filter is On. Lower frequencies noise
is eliminated and the target sound
becomes clearer.
Turning the MIC. filter
On/Off
During recording pause, press
1
MENU.
Select "Camera Functions Setup"
2
"MIC. Filter"
Press the confirmation button to
confirm, then MENU to end.
When the function is turned On,
" " appears in the LCD
monitor (p.50).
• The MIC. filter setting is
retained in memory even when
3
the power is turned off.
• If you set this function to
"On", it is recommended to set
the function to "Off" after
recording before turning off
the power unless you always
intend to use this function.
Note
The MIC. filter does not work if you
are using an external microphone
(p.86).
-RW (VF) R +RW
"On"/"Off"
HDD BD-R RAM -RW (VR)
BD-RE
Restoring all the
Recording Settings to
Default (Full Auto)
You can reset the following manually
adjusted recording settings to their
defaults with the press of a single
button.
Function Default See
Focus
Exposure
BLC (Backlight)
Program AE
(recording mode)
White Balance
EIS (Electronic
Image Stabiliser)
MIC. Filter
Setting the recording
settings to full auto
During recording pause or recording,
press FULL AUTO.
"FULL AUTO" appears in the
1
LCD monitor for a while and the
settings are reset to their default
settings.
-RW (VF) R +RW CARD
Auto p.73
Auto p.74
Off p.75
Auto p.76
Auto p.78
On p.80
Off p.81
81