Craftsman 139.53992D Owner's Manual page 24

ONE-PIECE D OORS
Please readandcomply withthewarnings a nd
reinforcement instructions o ntheprevious page.
Theyapply to one-piece d oorsalso.
• Center t hedoorbracket o nthetopofthedoor,in
linewiththeheaderbracket a s shown. M arkeither
theleftandright,or thetopandbottom holes.
• Drill 5 /16"pilotholesandfasten the bracket w ith
hardware supplied.
If thedoorhasnoexposed framing, d rill3/16"pilot
holesandfasten thebracket w ith5/16"xl-1/2" l ag
screws (notprovided) tothetopof thedoor.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 LockWasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4
Header
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline
of Garage
Door
Horizontal and vertical
re##orcement is needed for
garage doers
(fiberglass, aluminum, steel,
door with glass panel, etc.).
(Not Provided)
Door
Bracket
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" lag screws (Not Provided)
to fasten door bracket.
Lock
Washer
, 5/16"
Top of Door
Top Edge
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
24