Advertisement
ESEC Hot Emement hdicator
Message
(HE}
After using any of the single, dual or Bridge radiant element positions the cooktop wiii
become very hot, Even after turning the control knob to OFF, the cooktop will remain hot for
some time, The ESEC control monitors the temperature of the cooktop and displays the
message "HE" (hot element) warning when the cooktop is still too hot to touch (See Fig,1 ), if
the HE message appears in the window, the control can still be turned on again for use,
ESEC Error
mndicator Message
(Er)
An error message wiii be displayed (flashing "Er') at power up (or after a power failure) if ANY
of the surface control knobs were left in the ON positions (See Fig, 2), if a power failure
should occur, be sure to set aii of the 4 surface control knobs to the OFF position, This wiii
reset the surface controls,
Be sure to reset the clock (See page 15), Once the surface controls have been set to the
OFF positions and the clock has been set with the correct time of day, the surface controls
should return to normal operation, if the surface controls do not function and the "E¢'
message remains in any display after following these procedures, contact an authorized
servicer for assistance,
ESEC Lockout
Feature
( ° - )
The Self-Clean feature will not operate whenever a radiant surface element is ON, Conversely
the ESEC feature will not operate during the Self-Clean cycle, Whenever the ESEC Lockout
feature is active, "- -" may appear in any display window (See Fig, 3), if any of the surface
elements are still hot during active Lockout, "HE" (See Fig, 1 )wiii appear in the window
instead of the "--" message,
The
Single
Radiant
E_ernents
_some models)
Some models have single radiant surface elements at 2 locations: the right rear (Fig, 5/and
left rear (Fig, 6) element positions, The BRIDGE _some models_ element position can also be
used as a single element (See Bridge Element Operating
nstructions on pages 10-11 I.
Fig. 1
Fig. 2
To Operate
the SingJe EJements
('some models}:
1,
Place correctly sized cookware on the radiant surtace
element,
2,
Push in and turn the surface control knob in either direction
to the desired setting using the ESEC digital display
window for the desired setting (Fig, 4), Turn (do not push)
sir_
the knob to adjust the setting if desired, Start most cooking
operations on a higher setting and then turn to a lower
setting to finish cooking, Each surface element provides a
constant amount of heat at each setting, A glowing red
surface heating area extending beyond the bottom edge of
the cookware indicates the cookware is too srnaH for the
surface heating area,
3,
When cooking has completed, turn the surface control
knob to OFF before removing the cookware, Note: The HE
message will appear after turning the control knob to OFF if
the cooktop is still hot and wiii remain on untii the heating
surface area has cooled sufficiently,
OFF
Le
hi
#
\
_
ight
Rear
Fig. ,_
Fig. 3
Fig. 5
Right Rear Element
,some models,.
Note: See page 8, Fig, 5 for recommended
control settings,
Radiant surface elements may appear to have cooled after they have been
turned off, The gJass surface
may still be hot and burns may occur if the glass surface is
touched before it has cooled sufficiently,
Fig. 6
Left Rear Element
(some models).
Advertisement
