Craftsman 917.28033 Operator's Manual page 9

ransmisi6n y la
rdacorreas.
acionario (A) y
tral (C).,
oia la parte de
cuidado, retire
da de la trans-
)a y pas_,ndola
ventilador (D).
_1 motor movi6-
te de atr&s del
direcci6n (F) y
®
parte de atr&s
.-tor, pas&ndoia
._cciSn(F) y del
ue t freno (G)o
le adelante del
._a del motor (E)_
a de atr&s del
7ueva la correa
,r del ventilador
de la polea de
e la correa est6
Fee,
_6n central (C).
6n estacionario
(B),
calce en todas
_entro de todas
'ARA MONTAR
Jlo del manual).
Seat
switch
Slot
Seat
P
6_
7.
Wiring harness
Remove tape and discard.
Lower seat into operating position and
sit on seat° Press brake pedal all the
way down. If operating position is not
comfortable, adjust seat.
TO ADJUST SEAT
Grasp adjustment handle and pull up, slide
seat to desired position and release adjust-
ment handle.
Slot Tape
Flat
washer
Seat
pan Adjustment
Bolt Tab handle
NOTE: "You may now roll your tractor off
the skid. Follow the instructions below to
remove the tractor from the skid.
,_kWARNING: Before starting, read,
understand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well - ventilated area. Be sure
the area in front of tractor is clear of other
people and objects_
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Raise attachment lift lever to its highest
position,
2. Release parking brake by depressing
brake pedal.
3 Place freewheel control in "transmission
disengaged" position" (See "TO TRANS-
PORT" in Operation section of manual),
4. Roll tractor forward off skid.,
5. Remove banding holding the deflector
shield up against tractor,.
Continue with the instructions that follow.
TO ASSEMBLE BAGGER
. Do not operate machine without the
entire grass catcher, or other safety
devices in place and working.
• Feed top bagger frame tube (1)through
loop (2) atthetop of bagger fabric (leave
loop segments on the ends loose).
• First, align two holes as shown on side
of bagger frame upper weldment (4)
with corresponding holes in top bagger
frame tube (1).
• Install two 1/4" - 20 x 1 25 carriage bolts
(5) and secure with two 1/4" nuts (6).
• Align two holes on opposite of bagger
frame upper weldment (4) with corr-
esponding holes in top bagger frame
tube (1).
• Install two 1/4" - 20 x 1.25 carriage bolts
(5) and secure with two 1/4" nuts (6).
Install two more carriage bolts (7) rear-
ward on sides of top bagger frame tube,
hand tightening nuts (8).
9