Craftsman 917.28033 Operator's Manual page 11

Jela piezade
encuentra e n
_ra(H),y fijelo
' unresorte de
_.iiI
embrague (Q)
3ntrae! soporteo
_rencima de la
e la correa (G).
rea encaje bien
:te lacortadora.
la posici6n de
. Push plastic closeout (27) back so that
it snaps into place behind retaining ribs
(28).
• Line up holes in grass deflector (29)
with bosses in bagger cover°
• First install 1/4" hex bolt (30) into the
side as shown.
, Then install 1/4" hex bolt (31) into the
top as shown.
TO INSTALL BAGGER COMPONENT
TO TRACTOR
TO INSTALL BAGGER FULL LEVER/
PADD_LE i
" Before installation, tractor engine must
be shut off and parking brake engaged.
• Standing behind the tractor with the
bagger removed from the backplate
(I), identify the bag full switch (2) area..
_.. _'L. _"
Take bagger full lever (3) and insert
tab(4) into upper slot and rotate until
lever (3) snaps into position.
Front Qf Tractor
:liras de l calibre
_iento la corta-
itulo de Manejo
, Before installation, tractor engine must
be shut off and parking brake engaged.
' Install latch springs (1) in mounting
holes on back plate,
, Insert hex bolt (2) through each latch
spring hole and corresponding hole in
back plate.
, Fasten lock nut (3) to bolt on the other
side of back plate.
. For the heaviest/wet grasses, do not
attach paddle (5),,
• For lighter grasses use the paddle (5)
on setting "1 ", "2", or "3" ("3" being for
the lightest or dry grass)°
• Choose your setting and rotate the
bagger paddle (5) so that the desired
number (setting) faces you°
@
• Place paddle (5) on lever (3) so that tab
(6) at the bottom of the bagger full lever
(3) goes through appropriate rectangular
slot and make sure holes in bagger
........ full lever (3) and paddle (5) line up.
• Feed screw (7) through bagger full
--- paddle (5) and lever (3) holes and
............. fasten using nut (8). ....................................
• Setting may be changed by loosening
fasteners (7 and 8), removing!rotating
paddle (5), and tightening again.
11