Installing Rear Fence Guide Bars - Craftsman Contractor 113.299112 Owner's Manual

tNSTALU_G REAR FENCE GUIDE BAR
I. From among tt_e _ooseparts find the following:
4 Sq. head screws, 5/16--18 x 1" long
2 Sq. head screws, 5/16-18 x 3/4" torT,q
6 Externat lockwashers, 5/16" I.D.
6 Flat washers, 21/64" I.D.
6 Hex nuts, 5/!6-18
1 Rear guide bar 6!" tong
2. Lay the rear guide bar on the rear of the saw table
with the left end extending 6-1/2" past the le_ edge
of the extension.
3, Slide the head of four 1" long screws in the siot until
they line up with the four holes in the saw tabMe.
Then from each end, slide in one 3,/4" screw untii it
lines up with bracket slot on end of extensions,
4. Turn rear guide bar with ,,vide section up and screws
facing saw. Insert screws into holes in saw table and
bracket. Install flat washer, lockwasher and 5/16-t8
nuts to screws from inside of saw table and bracket.
Finger tighten the nuts. With a straight edge along
the right of the saw blade, align the notch on the top
of the rear rail with the right side of the saw btade.
Tighten nuts from center of saw tab!e first, alternate
left and right.
5. Adjust the extension table brackets against the back
of the guide bar and then finger tighten the nuts.
6. Shims may be required between the rear guide bar
and saw table. See INSTRUCTIONS FOR ADJUST-
ING RIP FENCE GUIDE BARS.
3i4" SQ, HD. SCREW
5/t6" EXTERNAL 2t/64 '! WASHER 5/16" HEX NUT
LOCKWASHER
SQ HEAO
SCREW
5/16-
5/16-18 X 1"
LOCKWASHEP;
FLAT WASHER _,,._ HEX _T
SCREW
SQ. HEAD 511 6-! B X 3/4" BRACKET
SCREW
5/16-18 X 1"
23