Operating Instructions; Gf75-1 Start Up Procedure - FPI Dell-Point Europa 75 Owners & Installation Manual

OPERATING INSTRUCTIONS

14

GF75-1 START UP PROCEDURE

GF75-1 Start Up Procedures
1 2
A
1 & 2 Pre-set
COMB.
AIR
FLOW
3 4
ASH
EXTR.
B
5 6
HEAT
LEVEL
7 8 9
WOOD
CORN WHEAT
PELLET
10 11
MANUAL
FEED
Start up from Cold Stove with Fuel in Hopper and Auger
(To Start from Empty Hopper of fuel, refer to Starting Procedures section in Manual.)
For best start-up regardless of fuel being used in your stove, use 1 & 1/2 measures
of wood pellets as fuel for starting. This will quickly raise the burner and vent
temperatures providing a better and faster start-up. Failure to use wood pellets
for start up could result in slow and diffi cult start-up. Before starting each fi re,
fi rst make sure the burn pot is completely emptied out. Never attempt to start
with a burn pot containing previously burned pellets.
1) For best results in starting your GF75-1
stove, use only the approved fi re starter
material supplied. (This is available for sale
from your GF75-1 dealer). Fill the measuring
cup one and a half complete fi lls, and pour
into your burn pot.
Sprinkle a capfull (from the starter material container) of
starter material on top of the wood pellets in the burn
pot. Using a match, ignite the starter material and close
the fi rebox door.) Do not stir the starter material into the
wood pellets).
2) Immediately press on one of the green icons (7, 8 or 9) representing the type of fuel
used in the hopper. The display B will indicate A1 and A2 for a combined total of 30
minutes.
Please note that icon 10 (stop) will be the only functional key during the fi rst 30
minutes of the starting mode. All other keys are over-ridden in the process. When the
starting procedures are completed after the 30 minutes, display A will indicate "10"
(ash extraction) and display B will indicate "3" (fuel feed rate).
3) Your stove is now ready to be adjusted to the heat level desired, by using icon 5 and
6. Setting Feed Rate:
1) 1 - 1 1/2 lbs. 2) 1 1/2 lb - 2 lbs.
4) 3 lbs. 5) 4 lbs.
For best and most effi cient results, use the laminated Mini-helic gauge setting guide
(supplied with the manual) to make any combustion air adjustments. These are
guidelines based upon the most effi cient burns on average fuel types. These settings
may vary a little with fuel quality variations.
Stop Button
Icon 10 is used to shut the stove down. Note, the ash management system continues
to operate in this mode. The electronic panel will display EE.
Icon/Display Description
Combustion Blower
at factory
3 & 4 Pre-set Ash-extraction
at factory
A Display Settings 1 to 20
for icons 1-2-3-4
5 & 6 Heat level 1 to 5
B Display Settings 1 to 5,
C1 & C2 and error codes
7 Wood Pellet Fuel Setting
8 Corn Fuel Setting
9 Wheat Fuel Setting
10 Stop Button
11 Auger Primary Mode
3) 2 - 2 1/2 lbs.
918-421g
GreenFire GF75-1 BioEnergy Stove