Advertisement
Available languages
Available languages
CRAFTSMAN
PROFESSIONAL
FULL WARRANTY
If this Craftsman Professional
product fails due to a defect in material or workmanship
within three years from the date of purchase, return it to any Sears store,
Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement
if repair proves impossible).
This warranty applies for only one year if this product is ever used for commercial
or rental purposes.
This warranty covers
ONLY defects
in material
and workmanship.
Sears will NOT pay for:
• Expendable
items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
Preventive maintenance,
or repairs necessary due to improper fuel mixture, contaminated
or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
APPLICATIONS
on/off Control
As a trimmer:
•
Cutting grass and light weeds.
Edging
Decorative trimming around trees, fences, etc.
Shaft Grip
Throttle Lockout
Shaft Housing
D-Handle
_
Throttlecontrol
Primer Bulb
Shoulder
Strap Loop
Choke
Lever
Fuel Cap
Rapid
Rewind ® Cutting
Head
Air Filter
Muffler
Cover
Electric Start
Optional
Hassle Free ® PLUS
Adapter
Cutting
Head
Starter Rope
Cutting
Head
Grip
Shield
Line Cutting
Blade
iNSTALL AND ADJUST THE D-HANDLE
1.
Place D-handle over the
shaft housing and onto the
bottom clamp (Fig. 1). Place
it a minimum of 6 inches
(15.24 cm) from the end of
the shaft grip.
2.
Start screws with a large
Flat-head or T-25 Torx
screwdriver. Do not tighten
until making the necessary
handle adjustment.
3.
While holding the unit in the
operating position (Fig. 13),
move the D-handle to the
location that provides the best grip.
Shaft Grip
Fig. I
D-Handle
Clamp
4.
Tighten the clamp screws evenly, until the D-handle is secure.
INSTALL THE SHOULDER
SUPPORT
1.
Put the shoulder support on
using the clip.
(Fig. 2).
2.
Adjust by lifting slightly on
the rear of the lower clip then
push or pull the loose end of
the strap length to fit the
operator's
size and comfort.
(Fig. 3).
3.
Attach the shoulder clip to
the unit. (Fig. 4)
Fig. 2
Advertisement
