You MUST read them injury or serious malfunctioning. Refer to your carefully before installing or using the local Zanussi Service Centre. Always insist on appliance. genuine Zanussi spare parts. INSTALLATION GENERAL SAFETY...
INSTALLATION Positioning It is recommended that, for your convenience, the machine is positioned close to your washing machine. Whilst drying, the tumble dryer will expel a certain amount of warm, very moist air, and this should be removed from the room as quickly as possible to prevent condensation.
Page 6
Advice: If the hose is long and the room temperature low, the moisture might condense to water inside the hose. This is an unavoidable natural phenomenon. To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (dia.
Door reversal To make it easier to load or unload the laundry the door can be reversed. This operation must be carried out by qualified personnel. Operate as follows: - Remove the door by unscrewing the two screws (1) fastening the hinge to the cabinet (Fig. A). P0283 - Remove the safety catch (2) and the plug (3) by bending the two fastening tags (Fig.
Electrical connection This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use. WARNING: THIS APPLIANCE MUST BE EARTHED.
Drying Times Cotton and Linen Selector dial: up to 120 minutes Degree of drying required Degree of spin given Quantity Drying times mins 85-105 800-900 60-75 Store dry 80-100 1000-1200 55-70 75-95 800-900 40-55 Iron dry 70-90 1000-1200 35-50 Synthetics Selector dial: up to 80 minutes Degree of drying required Degree of spin given...
Drying sequence Before starting up for the first time it is advisable lo load a few moist cloths into the dryer and to let it run for about 20 minutes. This ensures that no dust and dirt is left in the drum. 1.
Useful hints Knitted textiles (knitted underwear) may shrink a little during drying. Please do not overdry items of this type. It is advisable to allow for Try to load to the maximum capacity of the shrinkage when choosing the size of new machine as small loads are uneconomical.
MAINTENANCE You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External cleaning Use only soap and water and then dry thoroughly. From time to time, apply a little wax furniture cream with a soft cloth.
SERVICING Before contacting your local Zanussi Service Centre, please make the following checks: The dryer does not start up The door is open. The plug is not fitted into the wall socket. There is no electricity supply from the wall socket.