Gigabyte GA-MA785G-UD3H User Manual page 42

Precharge Time
Options are: Auto (default), 2T, 3T.
Row Cycle Time
Options are: Auto (default), 11T~26T.
RAS to RAS Delay
Options are: Auto (default), 2T~5T.
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto
200 MHz~2.0 GHz Sets HT Link Frequency to 200 MHz~2.0 GHz.
VGA Core Clock control
Enables or disables the control of VGA Core clock. (Default: Disabled)
VGA Core Clock(MHz)
Allows you to manually set the VGA Core clock. The adjustable range is from 200 MHz to 2000 MHz.
This item is configurable only if the VGA Core Clock control option is enabled.
EPP Mode
(Note 1)
Enables or disables EPP mode when EPP memory is installed. Auto enables EPP mode for EPP mem-
ory to enhance performance. (Default: Disabled)
EPP Voltage Control
Allows you to configure EPP memory voltage. This item is configurable only if the EPP Mode option is
set to Auto.
Normal
By EPP
CPU Clock Ratio
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the CPU
being used.
CPU NorthBridge Freq.
Allows you to alter the North Bridge controller frequency for the installed CPU. The adjustable range is
dependent on the CPU being used.
CPU Host Clock Control
Enables or disables the control of CPU host clock. Auto (default) allows the BIOS to automatically adjust
the CPU host frequency. Manual allows the CPU Frequency (MHz) item below to be configurable.
Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow for automated
system reboot, or clear the CMOS values to reset the board to default values.
CPU Frequency(MHz)
Allows you to manually set the CPU host frequency. The adjustable range is from 200 MHz to 500 MHz.
Important It is highly recommended that the CPU frequency be set in accordance with the CPU specifi-
cations.
(Note 1) This item appears only if you install a memory module that supports this feature.
(Note 2) This item appears only if you install a CPU that supports this feature.
BIOS Setup
BIOS will automatically adjust the HT Link Frequency. (Default)
(Note 1)
Lets the BIOS optimize memory voltage settings. (Default)
Sets memory voltage according to the SPD data on the EPP memory.
(Note 2)
- 42 -