Chery QQ3 User Manual page 6


In general, it shall not exceed 100km
/ h;

Each gear shall avoid running at full
throttle.
Specification of Running
within the Range of 1,000 - 1,500
KM:

It can gradually increase to the
maximum speed or run at the
maximum allowable speed of the
engine.
Attentions Should be Paid after
the Period of Running In:
When driving a vehicle with speed meter,
the allowable maximum transient speed is
6000 r/min. When manually shift the
gear, if the cursor of speedometer reaches
the red indication area, it must switch into
the adjacent high gear.
Unnecessary high speed of engine should
be avoided. Change up as soon as possible
is favorable for fuel saving, work noise
in
decrease as well
pollution reduction.
However, engine speed should not be too
slow when cruise, only when the engine is
overloaded should it is necessary to shift
down.
When a vehicle is cold, no matter whether
it is on neutral position or driving on
certain gear, the engine should not work at
maximum speed.
When using a new tire, at the beginning it
has no optimal adhesive force. Hence,
running-in for first-life tire is also quite
necessary. Under such circumstance, when
driving during the first 100 km, it ought to
be relatively slow, and the driver should be
extraordinarily cautious.
Running-in for the new friction lining of
as environm ental brake is also quite necessary. When
driving during the first 200 km, ideal
friction of the brake is not available. In
this phase, if the braking is comparatively
poor, the driver can conduct properly
larger pedal pressure. This action is also
app licable to the newly replaced brake
friction lining.
After 800 km of cruise, the wheel nut of a
new vehicle must be again screwed down
to specified torque. Refer to the chapter
"Specification Parameters" in this manual
for proper torque value. Similarly, if a
Brief Introduction
6