Built-In Densimeter; Brake Pedal - Chery QQ3 User Manual

Built-in Densimeter

Check if battery terminals eroded (white
or red powder). For eliminating the
erosion, apply soda and water solution on
terminal, then solution will bubble and
turns orange. After this change, purge
solution with clean water and wipe off
with cloth or house paper. Apply Vaseline
on terminals to prevent possible erosion.
Follow below precautions for better
servicing battery:
Install battery firmly;
Keep battery top clean and dry.
Keep terminal and conn ection clean and
firm. Apply terminal and connection with
Vaseline and grease.
If electrolyte leaks, clean with solution of
113
water and soda immediately.
If vehicle is not driven for a long time,
remove battery terminals to prevent
discharge. Charge battery every 6 weeks.
！Notice
Battery acid has strong causticity and
flammable, follow below items:1.Keep
battery away from flame, spark and
fireworks.2.Keep battery acid away from
any part of vehicle body, costume or
painting surface.3.For circumstance
protecting purpose, store used battery in
specified site or disposed by CSSS.
Battery polarity can not be reversed,
otherwise accident will occur.
Service and Maintenance

Brake Pedal

Brake pedal free travel
Turn off engine. Pump pedal several
times to release vacuum in br ake system.
Press pedal slightly with hand until slight
resistance is felt. Measure pedal distance.
If distance is not as specified, adjust it at
nearest CSSS in time.
Brake pedal free 6—10mm
travel