Pc System Requirements; Hardware Installation; Software Installation - X10 AIRSIGHT XX34A User Manual

Indoor wireless/wired ip network camera
Table of Contents

Advertisement

                       

1.4 PC System Requirements

System configuration requirements:
CPU: 2.06 GHZ or above.
Memory: 256M or above.
Network Card: 10M or above.
Display Card: 64M or above memory.
Recommended Operating system: Windows XP, Windows Vista, Windows 7.

1.5 Hardware Installation

Follow the steps below to set up your camera hardware.
1. Install the Wi-Fi antenna.
2. Plug the power adaptor into the camera and into an AC outlet.
3. Plug the network cable into the camera and router/switch.
4. It takes approx 30 seconds to boot up the camera, then you will find the IP address from "IP Camera Tool"
(Figure 2.1).
5. When the power is on and the network cable is connected, the green LED on the rear panel will stay on.
The yellow LED will keep flashing, and the Indicator LED on the front of the camera will flash. (The indicator
LED can be controlled by software).

1.6 Software Installation

Attention: In order to make the installation correctly, we suggest that you turn off your Firewall and Antivirus
software before installing ActiveX. Correct software installation is essential to the successful use of this
product. Install the following software:
1. IP Camera Tool: Open the CD, double click "IPCamSetup.exe" then click next to complete the software
installation. (Figure 1.6, 1.7, 1.8).
 
Figure 1.4
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents