Kyocera TASKalfa 3050ci Operation Manual page 404

IPP Security
Select the IPP security level. This setup is available when SSL is On. The default setting is IPP or IPP over SSL.
NOTE:
IPP must be set to [On] in Protocol Detail on page 9-96.
IMPORTANT: After changing the setting, restart the network from the system menu, or turn the machine OFF
and then ON. For detailed information on restarting the network, refer to Restart Network on page 9-103.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [Next] of Secure Protocol, and then [Change] of IPP Security.
3
Press [IPP over SSL Only] or [IPP or IPP over SSL].
4
Press [OK].
HTTP Security
Select the HTTP security level. This setup is available when SSL is On. The default setting is HTTP or HTTPS.
NOTE:
HTTP or HTTPS must be set to [On] in Protocol Detail on page 9-96.
IMPORTANT: After changing the setting, restart the network from the system menu, or turn the machine OFF
and then ON. For detailed information on restarting the network, refer to Restart Network on page 9-103.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [Next] of Secure Protocol, and then [Change] of HTTP Security.
3
Press [HTTP or HTTPS] or [HTTPS Only].
4
Press [OK].
9-100
Default Setting (System Menu)