Correcting Black Lines - Kyocera TASKalfa 3050ci Operation Manual

3050ci/3550ci/4550ci/5550ci operation guide rev-2.2011.5
Hide thumbs Also See for TASKalfa 3050ci:
Table of Contents

Advertisement

Correcting Black Lines

Correct fine lines (streaks caused by contamination), which may appear on the image, when the optional
document processor is used.
The table below shows the available settings.
Item
Off
On(Low)
On(High)
Use the procedure below to specify the setting for correcting fine black lines.
1
Press the System Menu key.
2
Press [
], [Adjustment/Maintenance] and then [Change] of Correcting Black Line.
3
Press [Off], [On(Low)] or [On(High)].
4
Press [OK].
System Initialization
Initialize the hard disk installed on the machine to return it to the factory defaults..
Refer to System Initialization on page 9-91 about the initialization procedures.
Paper feed
direction
No correction performed.
Correction performed.
Select this item if a streak remains after using [On (Low)]. The reproduction of
fine lines on the original may becomes lighter than when using [On (Low)].
(streaks caused
by contamination)
Description
9-68
Default Setting (System Menu)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents