File Separation - Kyocera TASKalfa 3050ci Operation Manual

Use the procedures below to select the file format for transmission.
File Format
Image Quality
PDF
TIFF
Compression
Ratio Priority
JPEG
XPS
Original : A4
Zoom : 100%
Send : A4
High Comp.
PDF
Preview
Add Shortcut
Status

File Separation

Create several files by dividing scanned original data page by page, and send the files.
Use the procedures below to split scanned original data into separate files when sending scanned originals.

File Separation

Create and send a file for each page
of the original that was read.
Original : A4
Off
Zoom : 100%
Send : A4
Preview
Add Shortcut
Status
1
2
3
4
Destination
Standard Quality
Priority
Off Off
PDF/A Encryption
NOTE:
Cancel OK
10/10/2010 10:10
cannot be specified.
5
6
1
2
3
4
Destination
5
6
Each Page
NOTE:
abc_001.pdf, abc_002.pdf... is attached to the end of
the file name.
Cancel OK
10/10/2010 10:10
6-15
Press the Send key.
Place the originals on the platen.
Press [Org./Sending Data Format] and then [File
Format].
Select the file format from [PDF], [TIFF], [JPEG],
[XPS], and [High Comp. PDF].
When the color mode in scanning has been
selected for Grayscale or Full Color, set the image
quality.
If you selected [PDF] or [High Comp. PDF], you can
specify encryption or PDF/A settings.
If encryption is enabled, PDF/A settings
Press [OK].
Specify the destination, and press the Start key to
start sending.
Press the Send key.
Place the originals on the platen.
Press [Org./Sending Data Format] and then [File
Separation].
Press [Each Page] to set File Separation.
Press [OK].
Specify the destination, and press the Start key.
The scanned originals are sent after being divided
into files of one page each.
A three-digit serial number such as
Sending Functions
6