Selcall Menu; Selcall Parameters; Stun System - Vertex Standard VX-1700 Series Service Manual

Selcall Menu

SELCALL PARAMETERS

This parameter programs the various Selcall config-
urations of the radio.
Put a check mark into the check box to enable ad-
justment of its parameter from the transceiver's set
("menu") mode.
Note: The Selcall is only activated on the J3E mode.
The available parameters are Selcall, Kill System,
Stun System, Beacon Request, GPS Position Request.
GPS Position Send, Preamble, Offset Time, Radio ID,
Message, All Call, Answer Back, Group Call, Sub
Group Call, Tel Call, TX ID, and Selcall Self ID.
SELCALL
This parameter determines whether the radio is
able to receive or transmit a Selcall.
The available selections are "RX," "TX,"
"TX+RX," and "OFF."
RX: Enables the receiving of a Selcall and
disables the sending of a Selcall.
TX: Enables the sending of a Selcall and
disables the receiving of a Selcall.
TX+RX: Enables both the receiving and send-
ing of a Selcall.
OFF: Disables both the receiving and
sending of a Selcall.
KILL SYSTEM
This parameter determines whether the radio is
able to receive a Kill System command or trans-
mit a Kill System acknowledge command.
The available selections are "RX," "TX+RX," "POS
TX+RX," and "OFF."
RX: Enables the receiving of a Kill
System command and disables
the sending of a Kill System ac-
knowledge command.
TX+RX: Enables the receiving of a Kill
System command and sending
of a Kill System acknowledge
command.
POS TX+RX: Enables the receiving of a Kill
System command, and the send-
ing of a Kill System acknowledge
command along with the radio's
current position .
OFF: Disables both the receiving of a
Kill System command and send-
ing of a Kill System acknowledge
command.
: Requires the after-market GPS receiver.
Note: The KILL System is ignored while activat-
ing the ALE feature.
CE77 PC Programming Software

STUN SYSTEM

This parameter determines whether the radio is
able to receive a Stun System command or trans-
mit a Stun System acknowledge command.
The available selections are "RX," "TX+RX," "POS
TX+RX," and "OFF."
RX: Enables the receiving of a Stun
System and disables the sending
of a Stun System acknowledge
command.
TX+RX: Enables the receiving a Stun Sys-
tem command and sending of a
Stun System acknowledge com-
mand.
POS TX+RX: Enables the receiving of a Stun
System command, and the send-
ing of a Stun System acknowl-
edge command along with the
radio's current position .
OFF: Disables both the receiving a
Stun System command and
sending of a Stun System ac-
knowledge command.
: Requires the after-market GPS receiver.
Note: The STUN System is ignored while acti-
vating the ALE feature.
BEACON REQUEST
This parameter determines whether the radio is
able to receive or transmit a Beacon request fea-
ture.
The available selections are "RX," "TX,"
"TX+RX," and "OFF."
RX: Enables the receiving of a Beacon re-
quest and disables the sending of that
request.
TX: Enables the sending of a Beacon re-
quest and disables the receiving of a
Beacon request.
TX+RX: Enables both the receiving and send-
ing of a Beacon request.
OFF: Disables both the receiving and
sending of a Beacon request.
S M
35